AS 1112.3:2000 pdf free download – lso metric hexagon nuts Part 3: Product grade c

AS 1112.3:2000 pdf free download – lso metric hexagon nuts Part 3: Product grade c.
It, in special cases, specifications other than those listed in this Intemationai Standard are required, they should be selected from existing International Standards, for example ISO 724, ISO 898-2, ISO 965-1 and ISO 4759-1.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisons of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards.
ISO 225:1983, Fasteners — Bolts, screws, studs and nuts — Symbols and designations of dimensions. ISO 724:1993, ISO general-purpose metric screw threads — Basic dimensions.
ISO 8982:1992, Mechanical properties of fasteners — Part 2: Nuts with specified proof load values — Coarse thread.
ISO 965-1:1998, ISO general purpose metric screw threads — Tolerances — Part 1: Principles arid basic data.
ISO 3269:_1 , Fasteners — Acceptance inspection.
ISO4042:1999, Fasteners — Electroplated coatings.
ISO 4759-1 :_2), Tolerances foe- fasteners — Part 1: Bolts, screws, studs and nuts— Product grades A, B and C.
ISO 8992:1986, Fasteners — General requirements for bofts, screws, studs and nuts.
ISO 1 O683:—, Fasteners — Non-electrolytically applied zinc flake coatings.