AS NZS 2604:2021 pdf free download - Sunscreen products - Evaluation and classification

AS NZS 2604:2021 pdf free download – Sunscreen products – Evaluation and classification

Posted by

AS NZS 2604:2021 pdf free download – Sunscreen products – Evaluation and classification.
This document sets out procedures for determining the performance of sunscreen products in terms of their mean protection factors. It includes test methods for both broad spectrum and water resistant sunscreen products. This document also specifies appropriate detailed labelling requirements to be applied In conjunction with relevant legislation.
This document applies to sunscreen products represented as being suitable for topical use to protect human skin from the adverse effects of solar UV rays. It applies to both primary and secondary sunscreen products as defined.
As this document addresses protection against solar radiation Incident upon the surface of the Earth. protection against UVC does not fall within its scope. as it is filtered out by the Earth’s atmosphere.
Reference to ISO 24443 Is required for the determination of broad spectrum performance. Reference to ISO 24444 is required for the determination of the sun protection factor (SPF), Reference to ISO 16217 is required for the determination of water resistance.
2 Normative references
The following documents are referred to In the text In such a way that some or all of their content constitutes requirements of this document.
ISO 24443. Determination of sunscreen UVA photoprotection in vitro
ISO 24444. Cosmetics — Sun protection test methods — In vivo determination of the sun protection factor (SPF)
ISO 16217, Cosmetics — Sun protection test methods — Water immersion procedure for determining ater resistance
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
broad spectrum product
sunscreen product which has been shown, using the in vitro test method, to provide protection against the sun’s terrestrial LJVA and UVB rays
Note Ito entry: The an vitro test method Is specified in AppendlxC.
category description
designation of the level of protection given by a grouping of label sun protection factors
3.3
critical wavelength
wavelength at which 90 % of the cumulative area under the total absorbance curve from 290 nm to
400 nm
(d) Clear and appropriate directions for the use of the product in order to achieve the labelled claims shall appear on the container.
(e) With the instruction to “apply generously to the skin 20 minutes before skin exposure. then reapply frequently, and after swimming, sweating or towelling”; or words to this effect.
(1) Sunscreen aerosols and sunscreen spray pump packs, in addition to the above instructions. (a) to (e), should be labelled with the following statements or words to the same effect:
(i) Hold the container 10 to 15 cm away from the body and apply liberally and evenly until the product looks and teds wet on the skin.
(ii) Do not spray directly onto the lace. Spray onto hands and then apply to the face.
(lii) Do not apply the product in windy conditions.
(lv) Use In a well ventilated area and avoid inhalation.
6.2.2 Optional labelling
62.2.1 General
Provided the relevant requerements in C1au.e are satisfied, primary sunscreen products may also be labelled with the following:
(a) Category description (see Clause 6.2.2.2).
(b) The words “water resistant” (see CIatie6Z23).
6.2.2.2 Category description
Where a category description is to be given, the wording given in Table 1 according to the labelled SPF shall be used.
6.2.2.3 Water resistant primary sunscreen products
Water resistant primary sunscreen products may be labelled as “water resistant” provided that the words “water resistant” appear on the main label of the container in letters no larger than those used for the labelled SPF. Any claim of water resistance shall be qualified by a statement of the time for which the water resistance has been tested (in accordance with Appendi.U). LI to the maximum time claimable In accordance with Table 2.
6.3 Secondary sunscreen products
6.3.1 Mandatory labelling
Secondary sunscreen products shall be labelled as follows:
(a) The labelled SPF shall be marked on the container In durable and legible characters and In such a colour or colours as to afford a distinct contrast to the background colour.
(b) Numerical labelled SPFs greater than 50+ are not permitted. The terms 50+ or “50 plus” shall only be used on products with a tested SPF of 60 or greater. The labelled SPF shall be prefixed only by the expressions “sun protection factor” or “SPF.
(c) Clear and appropriate directions for the use of the product In order to achieve the labelled claims shall appear on the container.

Leave a Reply

Your email address will not be published. Required fields are marked *