ASME A112.19.3:2000 pdf free download.Stainless Steel Plumbing Fixtures (Designed for Residential Use).
2.3.3.1 Welded Kitchen Sink Drainboards. Drainboard sinks using wcldcd construction shall be fastened to sink compartments with continuous welds having visible surfaces of the weld ground smooth. and free from cracks and pits. Corners of drainboards on cabinet sink tops shall be welded and ground smooth.
2.4 Dimensions and Tolerance.
Fixtures shall conform to tile applicable dimensions and tolerances given herein. Where not otherwise indicated. a tolerance of plus or minus 1% shall apply. Maximum and minimum dimensions are not subject to a tolerance beyond the stated limits, except where given as nominal dimensions.
3 flXTURE TYPES AND SIZES
3.1 Kitchen Sinks
Common types and sizes are:
(a) flat-nm sink, single compartment (see Table Al);
(b) flat-nm sink, double compartment (see Table A2);
(c) ledge-back sink, single compartment (see Table A3);
(d) ledge-back sink, double compartment (see Table A4),
(e) ledge-back sink and tray combinations (see Table AS);
(f) ledge-back two-level sink, double compartment (see Table A6);
(g) ledge-back sink, single compartment with single drainboard (see Table A7);
(h) ledge-back sink, double compartment with single drainboard (see Table A8);
(I) ledge-back sink, single compartment with double drainboard (see Table A9);
(j) ledge-back sink, double compartment with double drainboard (see Table MO);
4.2 Flatness of Ledges or Flanges
A straightedge placed along any ledge or flange (see para. 1.6 for definitions) shalL not show more than 3/ in. (5 mm) variation a any point, except where such variation is an intentional design feature.
4.3 D.pth of Sink
Place a straightedge across the top of the rim and measure at right angles from the straightedge to the bottom of the sink as close to the outlet depression as possible, but not in the outlet depression. Except as identified herein, the minimum depth shall be 5’2 in. (139 mm). See Fig. A2 for method to measure sink depth.
5 MARKING
Stainless steel plumbing fixtures shall be legibly and permanently marked so as to be visible after installation with the name or registered trademark of the Manufacturer or, in the case of private brands sales, of the customer for whom the unit was manufactured. It is recommended that fixtures be likewise marked with stainless steel type number and thickness.
6 LABEUNG TO SHOW COMPUANCE
it is recommended that each fixture be labeled “Complies with ASME A112.19.3.”
