ASME B107.410:2008 pdf free download.Struck Tools.
ASME B107.410 wides performance and safety requirements for sphtting wedges that are Lised specilic-ally for splitting wood. It is rnttnded to serve as a guide in sckctmg,. testing. and usmg the hand tooLs covered It is not the purpose of this Standard to specify (he details of manufacturing.
This Standard is also meant to serve as a guide In developing manuals and posters and for training pcr sonnel In safe praCtices.
This Standard may be used as a guide Lw state authorities or other regulatory bodies in the fonnulation of laws ew regulations. It is also intended for voluntary use by establishments that use or manufacture the tools r.. rnd. [hr mrthods employed to ensure uwnpliancr with this Standard shall be determined by the proper regulahwy or .idm,ni.tra(ivr authority.
2 NORMATIVE REFERENCES
The following documents fiwm i part of this Standard to the extent sped tied herein. At the time of publication, the editions valid. All standards are subject to revision, and parties to agreements based cwi this Anwrxan National Standard are encouraged to investigate the possibility of applying the most recent editions of the documents indicated below. Copies of the publications may be obtained from publishers as indicated.
ANSI Z87 l-199S. Practice for Occupational Educational Eve and ace Protection
ANSI Z&15.4-199. Product Salety Signs and LabeLs
rublisher: American National Standards Institute (ANSi), 25 West 43rd Street, New You., NY 10036
ASIM E 18O0, Standard Tcst Methods for Rockwell Hardness and Rockwell Superficial Hardness of Metallic Materials
Publisher: ASTM International (ASTM), 100 Barr Harbor I)rivc. r.o, L3 C700. Wcst Conshohocken,,
Guide to Hand Tools — Iectkn, Safety lips. Proper Use and Care
Extractors shall be free of manufacturing defects such as scams, laps. pipes, and cold shuts that would peopardire sound construction, and shall withstand the tests spedhe’d in StCti4ifl 6.
5.2 Materials
The used In the mnufacturc of ezlrachws shall be such as to produce tools conforming to this Sandard.
5.3 Mechanical Properties
Hardnese of the cutting edgcs shall be 45 1-IRC to hO HIIC or equivalent. Hardness of the struck lace ot ttw extractor shall not exceed 43 IIRC or equivalent.
6 TESTS
Many tests rrqwrrd hrrrin are inherently hazardou%; adequate safeguards for personnel and property shall hr employed in conducting such tests.
Separate (new) samples shall be used in each of these tests. Failure to pa any one of the tests indicates the eitractors are not in compliance with this Standard.
Hardnr determination with respect to cutting edges and struck 1act shall be made on a 1itured til or on a suitable mounted rn unm4nmtrd specimen that has been cut 1mm the tocl using the wet abrasive method rn equivalent. Any h.rdnes test will be acceptable that utilizes equipment and methods equivalent to Rockwell hardnes determinations as spccafiid in ASTM £ 18.
6.2 Impact Test.
