ASME B30.26:2004 pdf free download.Rigging Hardware.
special: service that involves operation, other than normal or severe, which is approved by a qualified person.
hitch, choker: a method of rigging a sling in which the sling is passed around the load, then through one loop eye, end fitting, or other device with the other loop eye or end fitting attached to the lifting device.
in4ine loading: condition where the load is applied through the centerline of the rigging hardware at the intended bearing points.
jaw: a U-shaped load bearing connection, designed for use with a removable pin (see Fig. 5).
line pull: the tension load in a rope entering a rigging block (see Fig. 17).
live end: the section of wire rope that is tensioned under load. (see Figs. 10 and 11).
nianufocturer: The entity responsible for the physical production of an item.
pin, shackle: a steel bolt made to span the two shackle ears (see Fig. 3).
primary load fitting: the fitting on a rigging block that carries the highest applied load during use (see Fig. 17).
proof load: the specific load applied in performance of the proof tests.
proof test: a nondestructive load test made to a specific multiple of the rated load of the rigging hardware.
qualified person: a person who, by possession of a recognized degree in an applicable field or certificate of professional standing, or who, by extensive knowledge, training, and experience, has successfully demonstrated the ability to solve or resolve problems relating to the subject matter and work.
rated capacity: refer to rated load.
rated load: the maximum allowable working load established by the rigging hardware manufacturer. The terms “rated capacity” and “working load limit” are commonly used to describe rated load.
saddk: the base of a wire rope clip (see Fig. 10).
(b) When swivel hoist rings are to be used at temperatures above 4OOF (2tWC) or below —20°F (—29CC), the hardware manufacturer or a qualified person should be consulted.
(c) When carbon steel evebolts are to be used at ternperatures above 275SF (l35C) or below 30T (— 1°C), the hardware manufacturer or a qualified person should be consulted.
26-2.6.2 Chemically Active Environments
The strength of adjustable hardware can be affected by chemically active environments such as caustic or acid substances or fumes. The adjustable hardware manufacturer or a qualified person should be consulted before use in chemically active environments.
SECTION 26-2.7: TRAINING
Adjustable hardware users shall be trained in the selection, inspection, cautions to personnel, effects of environment, and rigging practices as covered by this Chapter.
SECTION 26-2.8: INSPECTION, REPAIR, AND REMOVAl.
26-2.8.1 Initial Inspection
Prior to use, all new, altered, modified, or repaired adjustable hardware shall be inspected by a designated person to verify compliance with the applicable provisions of this Chapter. Written records are not required.
26-2.8.2 Frequent Inspection
(a) A visual inspection shall be performed by the user or other designated person each shift before the adjustable hardware is used. Semi-permanent and inaccessible locations where frequent inspections are not feasible shall have periodic inspections performed.
(h) Conditions such as those listed in para. 26-2.8.4 or any other condition that may result in a hazard shall cause the adjustable hardware to be removed from service. Adjustable hardware shall not be returned to service until approved by a qualified person.
(c) Written records are not required.
26-2.8.3 Periodic Inspection
(a) A complete inspection of the adjustable hardware shall be performed by a designated person. The adjustable hardware shall be examined for conditions such as those listed in para. 26-2.8.4 and a determination made as to whether they constitute a hazard.
