IEC 60603-14:1998 pdf download - Connectors for frequencies below 3 MHzfor use with printed boards - Part 14: Detail specification for circular connectors forlow-frequency audio and video applications such as audio, video and audio-visual equipment

IEC 60603-14:1998 pdf download – Connectors for frequencies below 3 MHzfor use with printed boards – Part 14: Detail specification for circular connectors forlow-frequency audio and video applications such as audio, video and audio-visual equipment

Posted by

IEC 60603-14:1998 pdf download – Connectors for frequencies below 3 MHzfor use with printed boards – Part 14: Detail specification for circular connectors forlow-frequency audio and video applications such as audio, video and audio-visual equipment.
This part of IEC 60603 applies to circular connectors for low-frequency audio and video applications such as audio, video and audio-visual equipment.
The object of this part of IEC 60603 is to specify the dimensions and the general requirements and tests for the circular connectors for use in audio, video and audio-visual equipment.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this part of IEC 60603. At the time of publication, the editions indicated were valid, All normative documents are subject to revision, and parties to agreements based on this part of IEC 60603 are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. Members of lEG and ISO maintain registers of currently valid International Standards.
IEC 60512-2:1965. Electromechanical components for electronic equipment; basic testing procedures and measuring methods — Part 2: General examination, electrical cønhinuity and contact resistance tests, insulation tests and voltage stress tests
lEG 6051 2•5: 1992. Electromechanical components for electronic equipment: basic testing procedures and measuring methods — Part 5: Impact tests (free components), static load tests (fixed components), endurance tests and overload tests
IEC 60512-7:1993. Electromechanical components for electronic equipment: basic testing procedures and measuring methods — Part 7: Mechanical operating tests and sealing tests
ISO 468 1982. Surface toughness — Parameters, their values and general rules for spOcifylng requirements
3 IEC type designation
The connectors according to this standard shall be designated by the following system.

Leave a Reply

Your email address will not be published. Required fields are marked *